Mining
Platform and Crane
MULTITASKING AND RELIABILITY EVERYWHERE
MULTITASKING AND RELIABILITY EVERYWHERE
The HD9 can easily be configured with any type of platform and crane, guaranteeing robustness and stability in more extreme situations.
STABILITY
820 mm wide, unique heavy duty chassis with large sections:
Section dimensions:
HD9 3 and 4-axle and HHD9 3-axle 320x90x10 mm
HD9 and HHD9 4-axle 320x90x10+6*
Reinforced rear tandem on the standard version (2.5 m) and on the HHD version (2.9 m).
Even greater stability on the HHD version (2.9 m).
Availability of large tyres when greater stability and mobility is required on softer terrains.
CUSTOMISATION
"C-section" chassis with flat, parallel elements
Simple mechanical architecture
Simple electronic architecture with no control unit on the chassis frame
Wide choice of wheelbases and overhangs:
- wheelbase up to 5100 mm with 1900 mm overhang for 3 axles on chassis version.
- wheelbase up to 4100 mm with 800 mm overhang for 3 axles on tractor version.
- wheelbase up to 6960 mm with 2100 mm overhang for 4 axles
Completeness and easy configuration thanks to the availability of 4 PTOs (on engine, between clutch and gearbox, on gearbox and transmission).
Easy customisation of all types of tyre
Crane and mining platform
ROBUSTNESS
Unique heavy duty chassis
Two side members in high resistance special steel with a tensile strength of 530 Mpa.
Chassis torsional stiffness: up to 300 kNm
Loads up to 11 tons thanks to reinforced front drive axles and axles for the most arduous off-road use (routes with slopes or heavy loads concentrated on the front of the vehicle).
Loads up to 21.5 tons for each rear axle with standard width or maximum width of 2.9 m, standard reinforced suspension.
Maximum load on rear tandem of up to 40 tons and GVW up to 65 tons thanks to a reinforced rear tandem on both the standard HD9 version (2.5 m) and the HHD9 version (2.9 m).